replacement decal to go around igniter
requires removing the igniter button/body to install
high performance adhesive vinyl
UV grade ink
UV coated

installation:
remove old decal with soft, non-scratching plastic scraper
if necessary, use minimal non-staining adhesive remover applied with a soft cloth
liberally rinse area with clean water, dry with lint-free cloth
prepare surface with an alcohol prep pad/wipe (alcohol based disposable lens wipes work well)
allow to dry fully, repeat alcohol wipe and dry time if any visible dust has gathered on the install surface
carefully fold back 1/4" of the backing across the top edge of the decal, and align the decal cutout with the leg cutout
work side to side gently with thumb while removing the backing downward, being careful not to stretch the decal
finally, cover applied decal with paper towel or cloth and use a credit card or plastic scraper to ensure the entire surface of the decal is pressed down, or use a brayer if one is available