replacement decal for grill leg
high-performance adhesive vinyl
UV grade ink
UV coated

installation:
remove old decal with soft, non-scratching plastic scraper
if necessary, use minimal non-staining adhesive remover applied with a soft cloth
liberally rinse area with clean water, dry with lint-free cloth
prepare surface with an alcohol prep pad/wipe (alcohol based disposable lens wipes work well)
allow to dry fully, repeat alcohol wipe and dry time if any visible dust has gathered on the install surface
carefully fold back 1/4" of the backing across the top edge of the decal, positioning the top of the decal parallel to the bottom of the grill body, with the top of the decal being as far down that leg as the igniter decal is down its leg from the grill body
work side to side gently with thumb while removing the backing downward, being careful not to stretch the decal
finally, cover applied decal with paper towel or cloth and use a credit card or plastic scraper to ensure the entire surface of the decal is pressed down, or use a brayer if one is available